Gigabyte GA-M68MT-S2P User Manual page 72

Rebuilding an Array:
Rebuilding is the process of restoring data to a hard drive from other drives in the array. Rebuilding applies
only to fault-tolerant arrays such as RAID 1, RAID 10, and RAID 5 array. To replace the old drive, make sure
to use a new drive of equal or greater capacity. The procedures below assume a new drive is added to re-
place a failed drive to rebuild a RAID 1 array.
Launch the NVIDIA Control Panel from All Programs in the Start Menu.
Step 1:
In NVIDIA Control Panel, click Rebuild array un-
der Storage in the Select a Task pane.
Step 3:
Select the array to rebuild and click Next.
Step 5:
Click Finish to start the rebuilding process.
Appendix
Step 2:
When the NVIDIA Rebuild Array Wizard ap-
pears, click Next.
Step 4:
Select a drive to add to the array and click Next.
Step 6:
The rebuilding progress is displayed in the View
Storage Configuration sub-menu.
- 72 -