Gigabyte GA-M68MT-S2P User Manual page 70

B. Installing Windows Vista
(The procedure below assumes that only one RAID array exists in your system.)
Step 1:
Restart your system to boot from the Windows Vista setup disk and perform standard OS installation steps.
When a screen similar to that below appears (RAID hard drive will not be detected at this stage), select Load
Driver (Figure 3).
Step 2:
Insert the motherboard driver disk (Method A) or the removable storage device such as USB flash drive that
contains the SATA RAID driver (Method B), then specify the location of the driver (Figure 4). Note: For users
using a SATA optical drive, be sure to copy the driver files from the motherboard driver disk to a USB flash
drive before installing Windows Vista (go to the BootDrv\UDA\WinVista folder and save the whole sataraid
folder to the USB flash drive). Then use Method B to load the driver.
Method A:
Insert the motherboard driver disk into your system and browse to the following directory:
BootDrv\UDA\WinVista\sataraid
For Windows Vista 64-bit, browse to BootDrv\UDA\WinVista64\sataraid.
Method B:
Insert the USB flash drive containing the driver files and browse to the sataraid folder.
Appendix
Figure 3
Figure 4
- 70 -