1. Read the safety information that begins on page vii and "Installation guidelines"
on page 32.
2. Remove the drive cage filler panel.
3. Slide the drive release latch to the right and rotate the handle to the open
position.
4. Pull the lever to slide the drive filler out of the server.
5. Push the solid state drive in all the way until it clicks in the backplane.
Filler panel
6. Rotate the handle until the latch clicks closed.
7. Reinstall the drive cage filler panel.
8. Install the drive ID label on the server front bezel.
Release
latch
Chapter 2. Installing optional devices
55