Using The Master Power Key; Clearing Custom Programming; Re-Assigning Device Keys; Programming The Master Power Key - One for All OARP05S Owner's Manual

6. To add another macro, repeat steps 1 through 5,
substituting the new key sequence to be added in step 4.
NOTE: Programming more than five macros on the
same macro key overwrites previous settings.
Clearing a Macro Key
until it blinks twice.
3. Press once on the macro key you want to clear.
twice.
This macro key is now clear and ready for reprogramming
desired, repeat these to clear another Macro key.

Using The Master Power Key

The OARP05S Remote Control has a unique feature that
allows you to sequentially turn on or off up to five of your
home entertainment devices with a single key press.
NOTE: MASTER POWER (POWER) only works in the CBL/
SAT mode. If it is not programmed, only the cable box or
satellite receiver will turn on or off. In any other mode,
pressing MASTER POWER (POWER) once will turn the
selected device on or off.

Programming the Master Power Key

last-selected device key blinks twice.
4. For the first device you want in the power on sequence,
5. Repeat step 4 up to four more times to add the second,
k
third, fourth, and fifth device.
6. To save the settings and exit the program:
twice.
Using the Master Power Key
1. After programming, point the remote control at the
home entertainment devices on or off.
programmed sequence.
Clearing the Master Power Key
last-selected device key blinks twice.

Re-Assigning Device Keys

The OARP05S Cable Replacement Remote can be set up to
control a second device of an already-assigned type.
audio device as follows:
NOTE: Performing the steps below will overwrite the
device you've programmed for the device key.
these and substitute the key sequence using the following
chart:
NOTE: Only one device can be assigned to an unused
device key at a time.
DVD/VCR as 2nd AUD key
DVD/VCR as 2nd TV key
DVD/VCR as 2nd CBL/SAT key
DVD/VCR back to DVD/VCR
To re-assign another unused device key, substitute it for the
key, perform:

Clearing Custom Programming

The OARP05S Remote Control contains a Custom
all custom programming, except your setup codes and
reassigned device keys.
IMPORTANT: Executing this program will erase all custom
settings for Volume Lock, learned keys, Macro keys, and
Channel Lock. However, your device programming remains.
last-selected device key blinks twice.
pauses, and blinks twice again to confirm that all
custom programming is cleared.