Checking The Codes; Programming Master Power; Programming The Power Key For Master Power - One for All URC-6131 User Manual

IMPK6VR manual 1.0 2/21/03 5:46 PM Page 12

CHECKING THE CODES

If you have set up the remote control using the
Searching For Your Code procedure (on the previous
page), you may need to find out which four-digit code
is operating your equipment.
For example,to find out which code is operating your TV:
1. On the remote control, press
2. Press and hold
blinks twice, then release
3. Enter - -
9 9 0
4. To view the code for the first digit, press
once.Wait 3 seconds, count the LED
blinks (e.g., three blinks = 3) and write
down the number in the leftmost box in
the TV code boxes on page 10
NOTE: If a code digit is "0", the LED will not
blink.
5. Repeat step 4 three more times for
remaining digits. Use
digit, for the third digit, and
3
fourth digit. Write down the code digits in
the remaining TV code boxes on page 10.
6. To check for codes of other devices, repeat
steps 1 through 5, but substitute the
appropriate device key for each device you
are checking.Write down the device's code
digits in the appropriate code boxes on
page 10.

PROGRAMMING MASTER POWER

In its default state, the
POWER
remote control will individually power your home
entertainment devices on or off. However, you can also
program a Master Power function onto the
that will sequentially turn on or off all the devices with
a single key press.

Programming The Power Key For Master Power

1. Press and hold
blinks twice, then release
once.
TV
until the (red light)
SET LED
.
SET
. The will blink twice.
LED
1
for the second
2
for the
4
key on the URC-6131
key
POWER
until the (red light)
SET LED
.
SET
12