Dell 3200MP - XGA DLP Projector Safety Instructions page 14

2 Focus ring
Adjusting Projection Image Size
Screen
(Diagonal)
Screen
Size
Distance
*
This graph is for user reference only.
Changing the Lamp
Replace the lamp when you see " Lamp is approaching the end of its useful life.
Replacement suggested!" message on the screen by carefully following these instructions. If this
problem persists, contact
CAUTION: The lamp becomes very hot with use. Do not attempt to replace the lamp after use until the
projector has been allowed to cool down for at least 30 minutes.
Lamp Changing Procedure:
1. Turn off the projector and disconnect the
power cord.
2. Let the projector cool for at least 30
minutes.
3. Lossen the two screws that secure the
lamp cover, and remove the cover.
4. Remove the two screws that secure the
lamp.
5. Pull up the lamp by its metal handle.
6. Reverse steps 1 through 5 to install the
new lamp.
7. Reset the lamp by selecting the left Lamp
Reset icon in the OSD
8. Dell may require that lamps replaced under
warranty are returned to Dell. Otherwise,
contact your local waste disposal agency for
the address of the nearest deposit site
Max 29.7" 82.5"
Min. 24.8" 68.8"
Max.
23.8"X17.8 66.0"X49.5" 108.2"X81.1" 149.8"X112.3" 192.0"X144.0" 234.2"X175.7"
(WXH)
Min.
19.8X14.9" 55.0"X41.3" 90.1"X67.6" 124.8"X93.6" 160.0"X120.0" 195.2"X146.4"
(WXH)
4.0' 11.1'
Dell.
Management tab.
135.2" 187.2" 240.0"
112.7" 156.0" 200.0"
18.2' 25.2' 32.3'
292.8"
244.0"
39.4'