Fujitsu MAX3036FC Product/Maintenance Manual page 72

Installation
(2) FORMAT UNIT command
Initialize entire recording surface of the disk with the FORMAT UNIT command. The FORMAT
UNIT command initializes entire surface of the disk using the P lists, verifies data blocks after
initialization, and allocates an alternate block for a defect block detected with verification. With
initialization, the value "00" is written into all bytes of all logical data blocks. Only the position
information of defect blocks detected with verification is registered in the G list. The specifications
are as follows:
a. Specifying CDB
Specify 0 for the "FmtData" bit and the "CmpLst" bit on CDB, 000 for the "Defect List Format"
field, and data pattern written into the data block at initialization for the "initializing data pattern"
field.
b. Format parameter
When the values in step a. are specified with CDB, the format parameter is not needed.
5-10 C141-E234