Presentation Mode - Honeywell 1900GHD-2 User Manual

code, set the time-out duration (from 0-300,000 milliseconds) by scanning
digits on the
Save. Default = 30,000 ms.

Presentation Mode

Presentation Mode uses ambient light to detect bar codes. The LEDs remain
off until a bar code is presented to the scanner, then the LEDs turn on automat-
ically to read the code. If the light level in the room is not high enough, Presen-
tation Mode may not work properly.
Note: If you are using a cordless charge base in Presentation Mode, the battery
will not charge unless the power supply is plugged into the base's
auxiliary power port.
4 - 8
Programming Chart
Read Time-Out
Presentation Mode
inside the back cover, then scanning