Oki B721dn Accessory Installation Manual

B721dn/B731dn/MPS5501 - Installing
Additional RAM
Install additional RAM to increase the memory
capacity of your printer in cases such as if
occur. Your printer supports 512 MB RAM.
Note
Use only genuine Oki Data products. The performance
cannot be guaranteed when other products are used.
The static electricity may cause damage to the parts.
Discharge the static electricity in your body by touching
grounded metallic parts, etc. before work.
Memo
For banner printing, installing additional memory is
recommended.
1 Turn off your printer, and then unplug all
the cables from the printer.
Reference
"Turning Off the Power" P.29
2 Open the access cover (1) on the right
side of a printer.
3 Loosen the screw to remove the metal
plate (2).
4 Make sure the LED (3) indicated by the
arrow is unlit.
If it is lit, wait until it turns off.
5 Insert the additional RAM (4) into the
printer.
Note
Be careful of the orientation of the additional RAM.
The additional RAM has small dents on its connector,
1
6 Insert the right side of the metal plate
(2) into the printer, close it, then secure
it by tightening the screw.
ENGLISH - 1
2
3
4
2