Removing The Memory Module(S); Replacing The Memory Module(S) - Dell Alienware M11x R3 Service Manual

Service manual
Hide thumbs Also See for Alienware M11x R3:
Table of Contents

Advertisement

Back to Contents Page
  Memory Module(s)
Alienware® M11x R3 Service Manual
  Removing the Memory Module(s)
  Replacing the Memory Module(s)
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
 
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
 
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ 
is not covered by your warranty.
 
CAUTION:
To help prevent damage to the system board, remove the main battery (see
computer.
You can increase your computer memory by installing memory modules on the system board. See "Specifications" in your Mobile Manual for information on the
type of memory supported by your computer.
NOTE:
Memory modules purchased from Dell or Alienware are covered under your computer warranty.
Your computer has two user-accessible SODIMM connectors.
 Removing the Memory Module(s)
 
1. Follow the instructions in
Before You
 
2. Remove the base cover (see
 
3. Remove the battery pack (see
 
CAUTION:
To prevent damage to the memory-module connector, do not use tools to spread the memory module securing clips.
 
4. Use your fingertips to carefully spread apart the securing clips on each end of the memory-module connector until the memory module pops up.
1
memory-module connector
3
memory module
 
5. Remove the memory module from the memory-module connector.
 Replacing the Memory Module(s)
 
1. Follow the instructions in
Before You
NOTE:
If you need to install memory modules in two connectors, install a memory module in the lower connector before you install a memory module in
the upper connector.
Begin.
Removing the Base
Cover).
Removing the Battery
Pack).
2
securing clips (2)
Begin.
Removing the Battery
Pack) before working inside the

Advertisement

Table of Contents
loading

Table of Contents