American Audio CDG-350 Operating Instructions Manual page 11

GENERAL FUNCTIONS AND CONTROLS - PLAYER UNIT
27. SWITCHED AUDIO OUTPUT R & L - Connect the audio cables to this output and the audio signal
can be switched between Deck 1 & Deck 2 using a "Q" Start Mixer. The red colored jack represents
the right channel output and white jack represents the left channels output.
28. DRIVE 1 AUDIO OUT R & L - These jacks send a left and right analog mono output signal. Use
these jacks to send standard audio to a mixer or receiver. The red colored jack represents the right
channel output and white jack represents the left channels output.
29. DRIVE 1 VIDEO OUT - This jack sends the CDG video graphics signal from Drive 1 to yout TV or
monitor. Plug the Video cable to the input connection on your TV or monitor.
30. VIDEO REGION STANDARD SELECTOR - This switch can select the video region for the CDG-
350. NTSC for the U.S. and PAL for Europe. This selector switch works exactly like the voltage selec-
tor switch. Choose the region standard for the location you are in.
31. REMOTE JACK - Connect the supplied 8 pin cable from this jack to the remote control's remote
connector. This will allow you to control the player functions with the remote unit.
32. VOLTAGE SELECTOR - Because power supplies vary from location to location a voltage selec-
tor switch has been incorporated in the unit's design. This switch can select a voltage input of 120v
or 220v to accommodate the two major power source. Always be sure to disconnect the power plug
before changing the voltage.
*Only dual voltage units have this switch.
33. POWER CONNECTOR - This is the main power connection. Only use the supplied polarized
power cord. Use of any other power may result in sever damage to the unit. Be sure the local power
matches the unit's required power.
34. DRIVE 2 AUDIO OUT R & L - These jacks send a left and right analog mono output signal. Use
these jacks to send standard audio to a mixer or receiver. The red colored jack represents the right
channel output and white jack represents the left channels output.
35. DRIVE 2 VIDEO OUT - This jack sends the CDG video graphics signal from Drive 2 to yout TV or
monitor. Plug the Video cable to the input connection on your TV or monitor.
36. VIDEO REGION FORMAT SELECTOR - This switch can select the video region for the CDG-350.
NTSC for the U.S. and PAL for Europe. This selector switch works exactly like the voltage selector
switch. Choose the region format for the location you are in.
American Audio - www.AmericanAudio.us - CDG-350 Instruction Manual Page 11
© ®