Quick Guide - Panasonic HDCTM300 - HD SD CAMCORDER Operating Instructions Manual

Quick Guide

∫ Charging the battery
1 Connect the AC cable to the AC adaptor and
the AC outlet.
2 Insert the battery into the AC adaptor by
aligning the arrows.
∫ Inserting the battery
Install the battery by inserting it in the direction
shown in the figure.
A Insert the battery until it clicks and locks.
∫ Inserting/removing an SD card
OPEN
Access lamp [ACCESS] A
≥ When this unit is accessing the SD card or
built-in memory, the access lamp lights up.
12
VQT1Z09
Charging lamp
[CHARGE] A
Lights up:
Charging
Goes off:
Charging completed
1) Open the LCD monitor.
≥ Check that the access lamp has gone off.
2) Open the SD card cover by sliding the OPEN
lever B.
3) Insert/remove the SD card.
≥ Face the label side C in the direction shown in
the illustration and press it straight in as far as
it will go.
≥ Press the center of the SD card and then pull it
straight out.
4) Securely close the SD card cover.
≥ Securely close it until it clicks.
∫ How to turn on the power
Turn on the power by changing the mode to
or while pressing the lock release
button A.
HDC-TM300
≥ Rotate the mode dial while at the same
time pressing in the lock release button if
changing from OFF to another mode.
≥ Align with B.
≥ Status indicator C
HDC-HS300
≥ Rotate the mode dial while at the same
time pressing in the lock release button if
changing from OFF to another mode.
≥ Align with B.
≥ Status indicator C
≥ To turn off the power, change the mode to OFF.
,