Using The Ipod/Iphone - Sony RDH-GTK37iP Operating Instructions Manual

Inserting batteries
Insert the two supplied R6 (size AA)
batteries, matching the polarities shown
below.
Notes
• Do not mix an old battery with a new one or
mix different types of batteries.
• If you do not use the remote control for a long
period of time, remove the batteries to avoid
damage from battery leakage and corrosion.
Installing the system
The system can be installed either
vertically or horizontally. Select the
installation style based on your
preferences.
Notes
• Install the system horizontally when
connecting iPod nano model to the Terminal
for Apple Device.
• Be sure to select the vertical sound effect
when the system is installed vertically
(page 22).
– Vertical installation
12 GB
– Horizontal installation

Using the iPod/iPhone

When connecting to the
Terminal for Apple Device
You can connect the models as follows to
the Terminal for Apple Device.
• iPod touch 5th generation
• iPod nano 7th generation
• iPhone 5
To prevent the iPod/iPhone from falling,
always secure the iPod/iPhone with the
holding arm when connecting to the
Terminal for Apple Device. When
removing the iPod/iPhone, lift up the
holding arm until it clicks and snaps into
position, and then disconnect the iPod/
iPhone from the Terminal for Apple
Device.
1
Place the iPod/iPhone onto the
Terminal for Apple Device.
2
Press the PUSH button until the
holding arm is released.
The holding arm flips out to secure the
iPod/iPhone.