Assign Interfaces To A Vlan; Assign An Ip Address To A Vlan - Dell Force10 S2410-01-10GE-24P Quick Start Manual

Step Task
To add tagged ports to the
2
VLAN, specify a single port in
unit/slot/port format to add to
the selected VLAN, or specify a
sequential port range as unit/
slot/port-unit/slot/port.
Specify a non-sequential port
range as unit/slot/port,
unit/slot/port,... Specify a LAG
ID as an integer (List LAG IDs
with show interface port-channel
brief.)
To add untagged ports to the
3
VLAN, specify either a port,
port range, port channel, or port
channel range, as described
above.
(OPTIONAL) Name the VLAN. name VLAN-name
4
Verify the configuration.
5
NOTE: Enable each port added to the VLAN.

Assign Interfaces to a VLAN

Executing the interface vlan command (Global Config mode) either creates a
VLAN or selects a previously created VLAN and then enters the Interface
VLAN mode, where you have access to commands that configure the selected
VLAN.

Assign an IP Address to a VLAN

You must have the optional SFTOS Layer 3 Package installed to
NOTE:
configure routing commands and to set IP addressing an interface. Refer to
the SFTOS Configuration Guide for information on implementing the
Layer 3 capabilities.
22
Installing the Software
Command Syntax
[no] tagged unit/slot/port
[no] untagged
unit/slot/port
show vlan id vlanid
Command Mode
Interface VLAN
Interface VLAN
Interface VLAN
Privileged Exec