HP ENVY dv6-7200 Maintenance And Service Manual page 104

5. Remove the hard drive (see
6. Disconnect the wireless antenna cables from the WLAN module (see
7. Remove the following components:
a. Optical drive (see
b. Keyboard (see
c. Top cover (see
Remove the display assembly:
1. Disconnect the display panel cable (1) from the system board.
2. Release the display panel cable (2) from the heat sink. (The display panel cable is attached to
the heat sink with double-sided tape.)
3. Disconnect the top speakers passthrough cable (3) from the system board.
4. Release the wireless antenna cables (4) from the clips (5) built into the base enclosure.
CAUTION:
support the display assembly can result in damage to the display assembly and other
computer components.
5. Remove the five Phillips PM2.5×5.5 screws (1) that secure the display assembly to
the base enclosure.
96 Chapter 4 Removal and replacement procedures
Hard drive on page
Optical drive on page
Keyboard on page
Top cover on page
Support the display assembly when removing the following screws. Failure to
52).
59)
61)
66)
WLAN module on page 57).