Configuring Client Pcs; Tcp/Ip Configuration - SMC Networks Barricade Plus SMC7004FW User Manual

C
ONFIGURING

TCP/IP Configuration

To access the Internet through the Barricade
Router with VPN, you must configure the network settings of the
computers on your LAN to use the same IP subnet as the Barricade
Plus. The default network settings for the Barricade Plus are:
Gateway IP Address: 192.168.2.1
Subnet Mask: 255.255.255.0
Note: These settings can be changed to fit your network
requirements, but you must first configure at least one
computer as described in Chapter 5 to access the Barricade
Plus' Web configuration interface. (See Chapter 4 for
information on configuring the Barricade Plus.)
If you have not previously configured TCP/IP for your computer,
refer to "Installing TCP/IP Protocol on Your PC" on page 5-1.
All PCs connected to the Barricade Plus must be set to the same IP
subnet as the Barricade Plus. The default subnet address of the
Barricade Plus is 192.168.2.X (where X means 2–254) and the subnet
mask is 255.255.255.0. You can set the IP address for client PCs either
by automatically obtaining an IP address from the Barricade Plus'
DHCP service or by manual configuration. See "Setting TCP/IP to
Work with the Barricade Plus" on page 5-5.
C
HAPTER
C
LIENT
Plus Broadband
™
3
PC
S
3-1