Normal Copying; Using The Original Table - Sharp AL-1611 Operation Manual

NORMAL COPYING

Power on

Using the original table

Turn the power switch on.
1
G
It will take about 35 seconds for the copier to warm up. However, you
can make desired settings and press the START key during warm-up.
Copying will start after warm-up.
G
If the copier has been programmed in the auditing mode, the START
key indicator will not light up and "––– " will appear in the copy
quantity display. Enter an assigned 3-digit account number. See page
16.
Place the original face down on the original table. Align
2
it with the original size scale.
G
Image loss (max. 4 mm) can occur at the leading and trailing edges of
the copies. Also image loss (max. 4 mm in total) can occur along the
other edges of the copies.
Close the document feeder cover or the platen cover.
3
Ensure that the copy paper size in the paper tray is the
4
same size as the original.
G
AL-1622 only Use the ORIGINAL SIZE ENTER key to select the
original size. Copy paper of the same size as the original will be
automatically selected. If desired, another paper tray can be selected
by pressing the TRAY SELECT key.
G
If paper of the required size is not loaded in the paper tray, use the
bypass tray and press the TRAY SELECT key to select the bypass tray.
Adjust the copy density.
5
G
This copier has three exposure modes to choose from — AUTOMATIC,
MANUAL, and PHOTO.
G
Automatic exposure is the standard initial setting for this copier. In this
mode, the characteristics of the original are "read" by the exposure
system and adjustments are automatically made. This optimizes the
contrast of the copied images by reducing the effect of coloured or
shaded background areas. See page 31 to adjust the automatic exposure
level.
17