Sound Volume; Changing Channels - Sharp Aquos LC-22GA3M Operation Manual

Sound Volume

■ To adjust the volume
● Press VOL (+) to increase the sound volume.
The numerical value increases.
VOLUME
50
● Press VOL (–) to decrease the sound volume.
The numerical value decreases.
VOLUME
10
■ To mute the sound
● Press e
e e e (Mute) to temporarily turn off the sound. The e
MUTE mark is displayed on the screen.
● Press e
e (Mute) or VOL (+)/(–) to turn the sound back to e e
e
the previous level. MUTE is automatically cleared when
one of the following buttons is pressed: POWER,
e e
VOL (+)/(–) or e e (Mute). e
VOLUME
10
LC-22GA3MX_E_P10-11.p65 11
Basic Operation (Continued)

Changing Channels

You can select channels using Channel Select or CH (
• To handle the increasing number of channels available, this
LCD TV set allows you to select up to 100 positions (Channels
0 to 99). One-digit and two-digit methods of selection can be
used. Follow the procedure shown below to select channels.
■ Using Channel Select
To select a one-digit channel (e.g., Channel 5):
1
Press 5 of Channel Select.
2
If "5-" is indicated and the picture does not change,
-/--
press to switch over to the 1-digit select mode
and press 5 of Channel Select.
To select a two-digit channel (e.g., Channel 15):
1
-/--
Press to set the 2-digit select mode.
2
Press 1 of Channel Select.
3
Press 5 of Channel Select.
NOTE
• Complete this procedure within 4 seconds, otherwise the selection
will not be made.
Changing channels with CH (
control.
Press CH ( ) and the channels change in the order shown below:
1 → 2 → 3 → . . . → 98 → 99 → 0 → 1 → 2 → 3 → . . .
Press CH ( ) and the channels change in the order shown below:
3 → 2 → 1 → 0 → 99 → 98 → . . . → 3 → 2 → 1 → . . .
■ Using A
A A (Flashback) A
A
● Press A
A A A A to switch the currently tuned channel to the
previously tuned channel.
● Press A
A A A A again to switch back to the currently tuned
channel.
04.8.25, 7:48 PM
)/( ).
1
PAL
B/G
--
1-
15
PAL
B/G
)/( ) on the remote
11