Sharp Aquos LC-26GD7E Operation Manual page 40

Troubleshooting
Problem
AV Link does not function
Various characters are displayed incorrectly in
analogue teletext mode
No sound via external digital audio amplifi er
The station overview doesn't show any
encoded stations, although the CI module and
smart card are plugged in.
The Picture-in-Picture (PIP) function is not
available.
I've changed the CI module and smart card,
but I can't fi nd the stations from the new
provider in the station list.
38
Possible cause
a) Euro AV cable is not fully wired
(pin 10 not wired)
b) Some video recorders can only take over the
stations in fi rst time operation of the TV
c) All or some terrestrial and cable programs
are stored at program places greater then 99
The wrong character set is set in the teletext
menu
a) The external digital audio amplifi er does not
support the selected sound format (Dolby
Digital, dts, MPEG)
b) TV set and external digital audio amplifi er are
not connected.
The CI module and / or smart card may not be
plugged in correctly (see the section entitled
"Inserting the Common-Interface module", see
page 10). If no information appears for the CI
module, smart card or CI software, the module
or card has not been installed correctly.
Possible solution
a) Replace the Euro AV cable
b) Restore the video recorder to the as-deliv-
ered state (see recorder manual)
c) Resort the terrestrial and cable programmes
so that they come to rest between 1 and 99.
Set the right character set: Teletext menu
– Setup – Character set: standard or the ap-
propriate character set.
a) Set PCM stereo on the DVD player in the
sound selection. Switch language/sound
selection (green button) to Stereo in the
DVB programme on the TV set in the status
display (END).
b) Connect Digital-Out from the TV set to a
Digital-In of the external audio amplifi er and
select the appropriate input on this.
Plug in the module and card correctly and
repeat the station search process (see page 13)
You are trying to watch two digital stations at
once. However, you can only watch one ana-
logue and one digital station at the same time.
When you exchange a CI module, you will need
to carry out the station search process again
before you will be able to watch the stations
provided by a new provider (see page 13).