Preparation
Setting the Display on the wall
CAUTION
• Installing the LCD Colour TV requires special skill that should only be performed by qualified service personnel.
Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting
or mounting that results in accident or injury.
Using an optional bracket to mount the Display
• You can ask a qualified service personnel about using an optional AN-37AG2 bracket to mount the Display
to the wall.
• Carefully read the instructions that come with the bracket before beginning work.
Hanging on the wall
AN-37AG2 wall mount bracket. (See the bracket instructions for details.)
Setting the AVC System with the stand
How to install the AVC System vertically using the stand unit.
• Use the supplied stand unit for installing the AVC System vertically in an upright position.
Stick each spacer to the
1
stand as shown.
Peel each spacer away from the paper
and attach to the four bulging areas
on the stand.
Bulge
Attach the stand using the
4
stand screws as shown.
NOTE
• When mounting the AVC System vertically, always use the supplied stand. Be careful not to block vent holes when
standing up directly on the floor or a flat surface as this can result in equipment failure.
10
Attach each cushion to
2
the stand as shown.
Peel each cushion
away from the
paper and attach
Stand
to the four areas
spacer
at the bottom.
Bulge
Attaching point
The AVC System installed
vertically with the stand.
Stand screw
About setting the Display angle
• Angular mounting is not possible with the
speaker attached.
• You can set the Display on the wall up to 20
degrees forward when the speaker is not
attached. Do not set the angle outside this
range.
3
Insert the stand into the AVC
System, making sure that the
thick and thin bulges of the
stand align with the big and
Stand cushion
small holes on the AVC
System.
Attaching point
Fit the stand to the AVC
System.
Bulge
Hole