Operation; Starting And Exiting Webpam - NEC Express5800 Series User Manual

3. Operation

This chapter describes how to start WebPAM and how to operate the screens to be displayed.

3.1 Starting and Exiting WebPAM

IMPORTANT:
NOTES:
Do not start more than one Web browser for a specific
controller at a time.
Whenever WebPAM is started, the security warning
screen appears. Click [Yes] to display the logon screen.
Even if you click "Installing certification..." to install
the certification, the security warning screen appears
again in the next start.
The user ID and password is set to "admin" by default.
In the first logon, specify "admin" as the user name
and password.
For changing the password "admin" to another after
the logon, see "3.4 Creating or Changing User
Account." Note that these user ID and password are
different from those required for logging into the OS.
The "Logical Drive **logical drive name** goes
offline" message may be registered the first time you
start the system. This is not a problem unless there are
any other warning/error messages before or after the
message and unless any abnormal statuses are found
in the WebPAM screen.
The "crypt32" error message with ID:8 may be
registered in the application log at WebPAM startup.
This has no effect on WebPAM operation.
Depending on the OS used, browser, and/or color
scheme, the images shown in this manual may be
different from the actual images.
If you attempt to start WebPAM and that is the first
time to start Internet Explorer with the server, a screen
of internet connection preparation may be displayed.
In this case, perform initial settings of Internet
Explorer for the server.
Whenever the system is started, the WebPAM service
checks the battery status and register the result to the
proper log.
- -
10