Table of Contents
Advertisement
TFT Viewing Angle Calibrate
When "Power Off", press the buttons 1, 2, 3, [BAND/ENTER] of remote control;
Then the monitor should display 'TFT ANGLE CALIBRATE";
The motor and gear drives are now back to their factory positions.
Brake Control
It is necessary to connect the Brake Control wire to the Hand-brake switch of the car.
While driving, the TFT monitor will display the alarm picture (see as follows) in order
to ensure the safety.
Under the Rear View Mode, the Brake Control function is no effective.
Telephone Mute Control
Connect the telephone mute control wire ＂TEL_MUTE＂ (see Wiring Diagram). If
there is a vehicle call comes in, the sound volume will mute off automatically, and
TFT monitor shows: ＂PHONE...＂; When call finished, the sound volume will
recover to former volume, and the words ＂PHONE...＂ disappear.
Auto Antenna Control
Connect the auto antenna control wire ＂AUTO_ANT＂ (see Wiring Diagram); The
antenna will lift when the unit startup; it will descend when the unit turnoff.
Reset
Press the [RESET] button to switch back to all the original factory settings.
Keep in mind this will erase all your preset radio stations and any EQ settings you
may have made and saved.
- 16 -
Advertisement
Table of Contents
