Removing Or Installing The Microprocessor - Lenovo ThinkServer 1043 Installation And User Manual

4. Connect the power cables to the system board connectors
connectors 1 and
Figure 48. Connecting the power cables
5. Connect the power cables to any other cards or devices.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation, go to "Completing the parts replacement" on page 64.

Removing or installing the microprocessor

This section provides instructions on how to remove or install the microprocessor.
Removing the microprocessor
Attention: Do not open your server or attempt any repair before reading and understanding the "Safety information"
on page iii and "Guidelines" on page 17.
This section provides instructions on how to remove the microprocessor.
CAUTION:
The heat sink and microprocessor might be very hot. Turn off the server and wait three to five minutes
to let the server cool before removing the server cover.
To remove the microprocessor, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
60
ThinkServer Installation and User Guide
2 .
3 , 4 , and 5 , and to the backplane