Lenovo ThinkServer 1043 Installation And User Manual page 21

Table 4. Front control panel LEDs (continued)
LED State
Ethernet 2 On
status LED
Blinking
Off
System status On
LED
Off
ID LED
On
Off
Each hard disk drive has two status LEDs on the front. The green LED 1 (bottom) indicates activity and
the amber LED 2 (top) indicates the RAID status.
Notes: If the onboard SATA and onboard SATA software RAID are configured, note the following:
• The SGPIO connector of the 4–port SATA cable in the chassis should be connected to the J45 connector
on the system board. See "Locating parts on the system board" on page 13.
• The function of the amber LED 2 is only available after you enter the operating system.
Table 5. Hard disk drive LEDs
Hard disk drive is not present.
Hard disk drive is present but is not active.
Hard disk drive is present and active.
Server is in the process of locating the hard disk drive.
RAID has failed.
Hard disk drive is rebuilding.
Note: For some models, the hard disk drive status information might be different from the information listed in
the above table. For these server models, refer to the following two tables for the hard disk drive LED status.
Table 6. Hard disk drive LEDs for the onboard SATA and onboard SATA software RAID configurations (some models)
Hard disk drive is not present.
Hard disk drive is present but is not active.
Hard disk drive is present and active.
Server is in the process of locating the hard disk drive.
RAID has failed.
Hard disk drive is rebuilding.
Color
Green
Green
Off
Red
Off
Blue
Off
Description
Description
Description
LAN is linked.
LAN is active.
LAN is not linked.
Failure. Over temperature or over voltage.
No failure.
System is identified.
System is not identified.
Green LED 1
(bottom)
Off
On
Blinking
On
Off
Blinking
Green LED 1
(bottom)
Off
On
Blinking
On
On
Blinking
.
Chapter 4 Locating parts, controls, LEDs, and connectors
Amber LED 2 (top)
Off
Off
Off
Blinking
On
Blinking
Amber LED 2 (top)
Off
Off
Off
Off
Off
Off
11