Kodak 305 User Manual page 14

BEFORE OPERATION
Install the print paper into the printer.
Place the printing paper in the correct orientation.
Make sure the paper roll is firmly installed.
Do not push down on the printing unit or the door.
If you push down on the printing unit or the door when they are open, this printer
may fall and it can cause damage or injury.
• Make sure to turn on the power before installing the
print paper. Otherwise, a paper jam may occur.
• Load the paper roll slowly into the printer. If it is
dropped along the ditches, the printer or accessories
may be damaged.
Remove the sticker and insert the print paper between the roller
and guide as shown right to feed it. When the buzzer sounds,
stop the paper feeding.
Remove the sticker before inserting the print paper between roller and guide. Make
sure to insert the paper straight.
Buzzer continues to sound until the printing unit is closed.
• Keep the rollers clean. Dirt on the rollers may produce poor print quality.
• When taking the print paper out, pull it up toward you by holding the paper
flanges.
• Make sure to turn on the power before replacing the print paper.
• Make sure to eliminate any slack from the print paper. If you carry out the
following steps without eliminating the slack, the print paper may be damaged.
Close the door.
CAUTION
NOTE
NOTE
NOTE
Direction of paper insertion
Roller
Guide
Print paper
Roller
11