Wired Lan Related - Samsung Q45c User Manual

Wired LAN Related

Q
<Wake On LAN> function
A1 <Wake On LAN> is a function that activates
the system in rest mode when a signal (such
as ping or magic packet commands) arrives
from network (wired LAN).
To use <Wake On LAN> function:
 Select My Network Places > View network
connections from the Desktop.
 Click the right button on the touchpad over
Local Area Connection, and select Properties.
 Click Configure, and select Power
Management tab. Select "Allow this device to
bring the computer out of standby", then click
OK. Restart the system.
– When turning the computer off when the network is
connected without selecting the <Wake On LAN>
function, the LAN LED may not be turned off.
– The <Wake On LAN> function is only available
when the LAN is turned on.
– When connecting a wired LAN while using a
wireless LAN, the <Wake On LAN> function may
not work. To use the <Wake On LAN> function,
select "Do not use Wireless LAN."
– Connecting wired LAN while using wireless LAN
may not execute <Wake On LAN> function.
Configure wireless LAN to "Disable" to use <Wake
On LAN> function.
 Click My Network Place> View network
connections on the Desktop.
 Right-click over Wireless Network Connection
and select Disable.
A2 The <Wake On LAN> function is configured so that
it is supported in Standby mode (S3). To use this
function in Hibernation mode (S4) or in the Turn Off
(S5) state, configure it as follows:
 Enter BIOS SETUP and select the Boot menu.
 Move to the Wake On Lan item and press the
Enter key. Change it from Disabled to Enabled
and press the Enter key.
Q
When I connected 100Mbps wired LAN and
the computer exits standby/hibernate mode,
a message informing 10Mbps wired LAN
connection appears.
A When the computer exits standby/hibernate mode,
restoring the network takes about 3 seconds. When
the network is restored, it operates in 100Mbps.
18