Setting The Indoor Unit Option Code - Samsung NS***HHXEH User & Installation Manual

Setting the indoor unit option code
In order to set the indoor unit option code using the wired remote controller, hold down the
buttons at the same time for 5 seconds.
1 The menu will display .
Press the button to enter the indoor unit option code
mode.
• The first digit represents the page number and the remaining five
digits are option codes.
2 Press the
button to change the page. You can change the
page from 0 to 3.
3 Press the
code in order.
• The option code which is currently setting will flicker.
4 Press the button to save the changed setting.
You will move to the menu selection display.
• Press the
• Option code will not be applied if you don't press the
• Setting indoor unit option code is only possible in Master wired remote controller.
You can only check the indoor unit option code in Slave wired remote controller.
• Setting indoor unit option code is possible when one indoor unit is connected. If more than 2 indoor
units are connected, you can only check the Master indoor unit option code.
28
INV HSP MA DUCT_DB98-33882A.indd 28
buttons and the button to set the option
button anytime during setup to exit without setting.
Page No.
Option code
button.
and
2011-5-31 18:54:40