Table of Contents
Advertisement
Circuit Description
4-2 Receiver Section
LOW NOISE AMPLIFIER (LNA)
The low noise amplifier featuring 1.6dB Noise
Figure and 19dB gain amplifies a weak signal
received from the base station to obtain the
optimum signal level.
DOWN CONVERTER (MIXER)
First local signal is applied to this down converter.
The down converter transfers the signal amplified
at the LNA into 85.38 MHz IF signal. 85.38MHz IF
signal is made by subtracting 1960°æ30MHz RF
signal from 2045.38°æ30MHz first local signal. The
LNA is Q303 and down converter is U302.
IF AMP
The IF amp (Q310) amplifies the output signal of
the down converter (U302).
RF IF AUTOMATIC GAIN CONTROLLER
(AGC) AMP
85.38 MHz IF signal is applied to IF AGC amp,the
AGC output level is applied to BBA (Base Band
Asic). The AGC amp (U303) keeps the signal at a
constant level by controlling the gain. Dynamic
range is 90dB, up gain +45dB, and down gain -
45dB.
RF BAND PASS FILTER (BPF)
The RF BPF(F302) accepts only a specific
frequency (1960°æ30MHz) from the signal
received from the mobile station. The bandwidth
is 60MHz.
IF SAW BAND PASS FILTER FOR CDMA
IF SAW BPF (F303) is used for CDMA system
having 1.23 MHz wide band and °æ630kHz band
width. The filter also climinates the image product
generated at the mixer.
4-4
BUFFER
Buffer (Q311) amplifies the signal from the VCO
(U305) to be applied to the local input of the down
converter (U302) when a phase is locked between
U304 and U305.
The VCO (U305) generates the signal having
2045MHz center frequency and °æ30MHz
deviation with the voltage control. PLL IC(U304)
controls this signal.
PHASE LOCKED LOOP (PLL)
Input reference frequency is generated at
VCTCXO (U306) and the local signal is generated
at VCO. PLL compares the two signals and allows
the VCO controlled by voltage to generate the
desired signal with pre-programmed counter.
VOLTAGE CONTROLLED TEMPERATURE
COMPENSATED CRYSTAL OSCILLATOR
It provides 19.68MHz reference frequency to PLL
(U304,U402) and BBA (U401). A correct frequency
tuning is made by the voltage control.
DUPLEXER
Duplexer (F301) controls to transmit through the
antenna only the signals within acceptable Tx
frequency range (1880°æ30MHz) and to receive
through the antenna only the signals within
acceptable Rx frequency range (1960°æ30MHz). It
also matches LNA(Q303) input in receiving part
and PA output in transmitter part with the
antenna.
Samsung Electronics
Advertisement
Table of Contents
