Samsung SCH-i830 Service Manual page 75

8-9. LCD KIT Assembly & Disassembly
LCD Assembly
1
place a doubled
faced adhesive tape
combine FPCB
1.remove the transparent cover on the gasket tape
2.place a double faced adhesive tape on the front of the
connector in parallel with the guide line.
3.remove the cover of a double faced adhesive tape
4.push SLIDE FPCB into TOP FPCB's connector until the
white guide line meets connector
5.press SLIDE FPCB over the adhesive tape
※ Caution
1. there should be no adhesive agent on the
Connector
2. make sure the FPCB is completely locked to
the connector .
3
1
.remove the transparent cover which protects FPCB on the
LCD panel
2.cover LCD TSP soldered place with an insulating tape.
3.cover the two places which are described in the photo
w
ith tape to prevent moisture inflow
※ Caution
1. use tools carefully not to scratch LCD panel
2. when lifting the LCD panel ,grab the sides
of LCD panel
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Exploded View/Disassembly and Assembly Instructions
2
1.place a green colored insulating tape over connector
belong the guide line
2.fold FPCB downward
3.align a black colored insulating tape along the guide line
of TOP FPCB and put it onto a green colored insulating
tape
※ Caution
1. make sure the FPCB and connector are
completely bonded
2. place the adhesive tape along the guide line
and make sure no vapor in the bonding part .
4
fold the connector lock
1.push the FPCB until the end of FPCB is completely
inserted into connector lock and shut down the lock
2.remove LCD cover and place TOP FPCB onto LCD panel
3.put the tape in parallel to guide line at the end of FPCB
bond
※ Cautions
1.be careful not to give any stress to FPCB
2.when lifting the LCD panel ,grab the sides of
LCD panel
8-9
put tape to fix FPCB