Table of Contents
Advertisement
Disassembly and Assembly instructions
5
1.Insert LCD FPCB into HINGE DUMMY.
2.Assemble the LOWER with FRONT by
Pressing the HINGE insertion part.
3.Insert CAMERA FPCB into FRONT HINGE
DUMMY.
4.Set the CAMERA on the camera position of
the LOWER.
※ caution
1) Be careful NOT TO TEAR the LCD
FPCB/CAMERA FPCB
FRONT HINGE DUMMY.
7
SCREW
RUBBER
SCREW
SHEET
Release the lever
SCREW 체결후 레버를
밀어준다.
after screwing
1.Screw 4POINTs of the Folder.
2.SCREW RUBBER(2POINT) to top,
SCREW SHEET(2POINT) to bottom.
3.Set the FOLDR ASS'Y to HINGE SCREW JIG.
4.Push the lever to lock completely.
5.Release the lever after screwing SCREW
2POINT.
6.Attach the RUBBER's intaglio to the HINGE's
center embossed part.
※ caution
1) PRESS the upper of HINGE firmly when
screwing HINGE SCREW 2POINTs.
2) Check the handset if there is any rising
and gap.
This Document can not be used without Samsung's authorization
inserting into the
SAMSUNG Proprietary-Contents may change without notice
6
1.Assemble the top part of FOLDER UPPER to
the LOWER exactly.
2.Press the UPPER firmly to assemble well as
the right picture.
3.Check the upper and lower's locking.
※ caution
1) Do NOT OVERPOWER when the LOCKING is
difficult.
2) Reassemble after disassembling and
checking each part when the LOCKING is
not good.
8
1.Connect the EL KEYPAD CONNECTOR to PBA
firmly with a ticking.
2.Set the PBA on the FRONT.
3.Assemble the VOLUME KEY FPCB to FRONT.
4.Screw 1 POINT of PBA's top part.
5.Connect the LCD CONNECTOR firmly with a
ticking.
6.Connect the CAMERA CONNECTOR firmly
with a ticking.
※ caution
1) Be careful NOT TO TEAR the EL SHEET
FPCB.
2) Do NOT PRESS T-FLASH CARD SOCKET
with fingers when connecting the EL
KEYPAD FPCB CONNECTOR.
5-5
Advertisement
Table of Contents
