Editing Channels; Satellite System Setup - Samsung 5 series User Manual

Satellite System Setup

The PIN input screen appears. Enter your 4 digit PIN number.
Satellite System Setup is available when Antenna is set to
Satellite. Before running Auto Store, set Satellite System
Setup. Then channel scan is run normally.
: You can choose the satellites for this
Satellite Selection
■
TV.
LNB Power (Off / On) : Enables or disables the power
■
supply for the LNB.
LNB Settings : Configures the outdoor equipment.
■
Satellite: Selects the satellite for receiving digital
broadcasts.
Transponder: Selects a transponder from the list or adds
a new transponder.
DiSEqC Mode: Selects DiSEqC mode for the selected
LNB.
Lower LNB Oscillators: Sets the LNB oscillators to a
lower frequency.
Upper LNB Oscillators: Sets the LNB oscillators to a
higher frequency.
Tone 22 khz (Off / On / Auto): Selects the Tone 22 kHz
depending on the LNB type. For a universal LNB it should
be Auto.
Signal Quality: Display the current status of broadcasting
signal.
Positioner Settings : Configures the antenna positioner.
■
Positioner (Off / On): Enables or disables the positioned
control.
Positioner Type (USALS / DiSEqC 1.2): Sets
the positioned type between DiSEqC 1.2 and
USALS(Universal Satellite Automatic Location System).
–– My Longitude: Sets the longitude for my location.
–– My Latitude: Sets the latitude for my location.
–– Satellite Longitude Settings: Sets the longitude of
user defined satellites.
User Mode: Sets the position of satellite antenna
according to each satellite. If you store the current
position of satellite antenna according to a certain satellite,
when the signal of that satellite is needed, the satellite
antenna can be moved to pre-populated position.
–– Satellite: Selects the satellite to set the position for.
–– Transponder: Selects a transponder from the list for
signal reception.
–– Moving Mode: Selects the movement mode between
discrete and continuous movement.
–– Step Size: Adjusts the step size degrees for the
antenna rotation. Step Size is available when Moving
Mode is set to Step.
–– Go to Stored Position: Rotates the antenna to the
stored satellite position.
–– Antenna Position: Adjusts and stores the antenna
position for the selected satellite.
–– Store Current Position: Stores current position as the
selected positioner limit.
–– Signal Quality: Display the current status of
broadcasting signal.
Installer Mode: Sets limits to the scope of movement
of satellite antenna or reset the position. Generally,
installation guide uses this function.
–– Limit Position (East / West): Selects the direction of
the positioner Limit.
–– Antenna Position: Adjusts and stores the antenna
position for the selected satellite.
–– Store Current Position: Stores the current position
as the selected positioner Limit.
–– Go to Zero: Moves the antenna to the reference
position.
–– Reset Positioner Limit: Allows the antenna to rotate
over the full arc.
Reset All Setting (OK / Cancel)
■
be reset to the initial values.

Editing channels

¦
Channel Manager Option Menu
(in Channel Manager)
1. Select a channel and press the
2. Edit the channel name or number using the Edit
Channel Name menu.
Edit Channel Name (analogue channels only): Assign
■
your own channel name.
: All satellite settings will
TOOLS button.
13
English