Installing The Tray Attachment - Fuji Xerox DocuPrint C5005 d User Manual

No. Name
13 US 2/3 Hole Punch Kit (US
standard) or
2/4 Hole Punch Kit (optional)
14 Center tray (Finisher transport
cover F)
Note
• The power cord connected to the Finisher-B1 is a connecting cord dedicated to the printer.
Do not connect this cord to any other devices than the printer.
• The HDD Extension Kit (optional) is required when installing the finisher.

Installing the Tray Attachment

When delivering A4
the outputs more neatly by installing the tray attachment supplied with the right middle tray.
1. Remove the tray attachment from the rear
of the right middle tray.
2. Install the tray attachment onto the middle
of the right middle tray as shown in the
diagram.
52
2 Basic Operation
Hole-punches outputs.
Note
• The distance between the two holes made with the US 2/3 Hole Punch
Kit (US standard) is 70 mm, which is different from the 80
made with the 2/4 Hole Punch Kit.
Prints are delivered here when they are unable to be delivered to the right
middle tray. Pull the cover upward when removing jammed papers.
Note
• Remove outputs delivered to the center tray frequently.
or B5 paper to the right middle tray without stapling, you can stack
Description
mm distance