Advanced Setting - Planet WL-U351 User Manual

u Authentication Mode: This parameter must be consistence with the associated wireless
station.
Open System – No authentication is needed among the wireless stations.
Shared Key – Only wireless stations using a shared key (WEP Key identified) are
allowed to connecting each other. Setup the same key as the wireless stations which
WL-U351 intends to connect.
Auto – Auto switch the authentication algorithm depending on the wireless stations
which WL-U351 is connecting to
u Key Length: Select the 64-bit or 128-bit to encrypt transmitted data. Larger key length
will provide higher level of security, but the throughput will be lower.
u Default Key ID: Select one of the keys (1~4) as the encryption key.
Key Value: The keys are used to encrypt data transmitted in the wireless network. Fill the
u
text box by following the rules below:
64-bit – Input 10 digit Hex values (in the "A-F", "a-f" and "0-9" range) as the encryption
keys. For example: "0123456aef".
128-bit – Input 26 digit Hex values (in the "A-F", "a-f" and "0-9" range) as the encryption
keys. For example: "01234567890123456789abcdef"

3.4 Advanced Setting

This screen allows user to enable/disable power saving mode, setup the fragmentation threshold
and RTS/CTS threshold of WL-U351.
u Power Saving Mode: Check the check box to enable power saving mode. You
may control the power consumption of WL-U351 by adjusting the save power
level from 1 to 4. The higher power save level selected, the lower power used.
But lower power is supplied may slow down the transmission rate of WL-U351.
13