Haier HWD1600BW User Manual page 20

prEWasH Button
Select this option to add an additional wash phase to a normal wash cycle. A
prewash icon will appear on the LCD screen to indicate that this option has been
selected. During operation of the prewash phase, detergent will be flushed from the
right side compartment of the dispenser and the prewash icon will blink. The icon
will disappear following the completion of the phase.
notE: Powdered HE detergent must be used with the prewash option.
DELay Button
Select this option to delay the start of a wash cycle. Pressing the button will
increase the delay time in increments of 30 minutes to a maximum of 24 hours.
After reaching the maximum 24 hours, one more button presses will deselect this
option. Otherwise a clock icon and the delay time will appear on the LCD screen.
After selecting this option, you have to press the "Start/Pause" button to activate
a delayed start. Once started, only the selected cycle and settings will be displayed
in a steady state, the clock icon will blink, and the time display will count down in 1
minute increments.
notE: An activated delay start can be cancelled at any time by turning the cycle
selector knob to "Power Off". As the knob is turned, the display will flash
the new position of the selector even though the washer is locked on the
operating cycle.
LCD sCrEEn
The LCD screen displays available cycles, settings, estimated cycle time, icons
for active options, lock indicators, and a status bar. The status bar indicates an
approximate duration for the operating cycle. One segment is displayed at the
start of a cycle and all segments are shown at the end. The LCD backlight will
automatically turn off after 2 minutes.
Door LoCK inDiCator
The washer door will automatically lock during operation. A lock will appear on the
LCD screen. If operation is paused, the door will unlock after one minute.
CHiLD LoCK inDiCators
After starting the washer, press the "Delay" and "Start/Pause" buttons at the same
time for 3 seconds to activate the Child Lock feature. A child icon will appear on
the LCD screen. This feature is intended to prevent accidental changes to the
operating machine. To cancel, press the "Delay" and "Start/Pause" buttons again for
3 seconds. The child icon will disappear from the LCD screen.
notE: This feature does not lock out the Cycle Selector knob.
18