Table of Contents
Advertisement
Configuring a Startup Image (Startup)
Procedure
[SET] * MENU * "Set Up" Tab * Startup
Display the image you want to use as your startup image and then select "On".
• The startup image does not appear when you turn on the camera by pressing
[p] (PLAY).
• You can specify a snapshot you recorded as the startup image, or you can use the
special startup image provided in the camera's built-in memory.
• If you select an audio snapshot as the startup image, the audio will not play at
startup.
• Formatting built-in memory (page 102) will delete the current startup image setting.
Specifying the File Name Serial Number Generation Rule
(File No.)
Procedure
[SET] * MENU * "Set Up" Tab * File No.
Use the following procedure to specify the rule that governs generation of the serial
number used in file names (page 92).
Tells the camera to remember the last used file number. A new file will
be named using the next sequential number, even if files are deleted or
if a blank memory card is loaded. If a memory card is loaded and that
Continue
card already has files stored on it and the largest sequential number in
the existing file names is greater than the largest sequential number
remembered by the camera, numbering of new files will start from the
largest sequential number in the existing file names plus 1.
Restarts the serial number from 0001 whenever all files are deleted or
when the memory card is replaced with a blank one. If a memory card
Reset
is loaded and that card already has files stored on it, numbering of new
files will start from the largest sequential number in the existing file
names number plus 1.
96
Other Settings (Set Up)
Advertisement
Table of Contents
