Acura 2006 RL Owner's Manual page 334

Collision Mitigation Brake System (CMBS)
To turn the system back on and turn
off the CMBS indicator, stop the
vehicle, turn the ignition switch to
the ON (II) position, then press the
CMBS OFF switch for about 1
second. When you do this, a CMBS
OFF message appears on the multi-
information display for about 5
seconds.
330
The CMBS indicator normally comes
on under these conditions:
When you manually turn off the
system.
When the system shuts off
automatically.
When you drive in bad weather
(rain, snow, fog, etc.).
If anything covers the front grille
(dirt, mud, dry leaves, wet snow,
etc.)
When the VSA system indicator
comes on (see page 339
When you turn the ignition switch
to the ON (II) position, the CMBS
indicator should come on for a few
seconds, then go off. If the
indicator comes on at any other
time and a CHECK CMBS
SYSTEM message appears on the
multi-information display, there is
a problem with the CMBS. You
can still drive your vehicle, but
CMBS will not be operating. Have
your vehicle checked by a dealer.
).