Table of Contents
Advertisement
STEREO ICON
To Play the AM/FM Radio
The ignition switch must be in the
ACCESSORY (I) or the ON (II)
position. Press the AUDIO button to
view the audio control display. Turn
the system on by pressing the
power/volume knob or the AM/FM
button (AM or FM button on
Canadian, Alaskan and Hawaiian
models). Adjust the volume by
turning the power/volume knob.
The band and frequency that the
radio was last tuned to are shown on
BAND
the display. To change bands, press
the AM/FM button (AM or FM
button on Canadian, Alaskan and
Hawaiian models). You can also
change bands by pushing the
interface selector up. Each time you
push it up, the band will change to
FM1, FM2, or AM. On the FM bands,
STEREO will be shown on the
navigation screen and ST on the
upper display, if the station is
broadcasting in stereo. Stereo
reproduction on AM is not available.
To Select a Station
You can use any of five methods to
find radio stations on the selected
band:
TUNE, SEEK, SCAN,
preset buttons, and
Playing the AM/FM Radio
TUNE ICON
TUNE
tune the radio to a desired frequency.
Press the
higher frequency, or the
to tune to a lower frequency. To tune
with the interface dial, push the
the
selector down, and turn the knob to
AUTO SELECT
.
TUNE. Then press ENTER on the
selector, and turn the knob to the
desired frequency. To exit the
TUNE mode, press ENTER on the
selector.
Use the TUNE button to
button to tune to a
button
CONTINUED
205
Advertisement
Chapters
Table of Contents
