Connecting Additional Equipment; Emergency Interrupt; Setting The Clock; User Guide - Philips VR287/07 User Manual

Connecting additional equipment

You can also connect additional equipment to the
et. For instance: satellite receiver, decoder or camcorder.

User guide

With OSD (On Screen Display) the corresponding functions
appear on the TV-screen. The most important button-functions
are displayed at the bottom of the screen. For instance:
DATE PROG START V/P END
01 01
------------------------
NEXT
-/+ 0-9
Throughout this instruction manual, use the following buttons
for these functions: 'Select', 'Enter'/'Adjust', 'Confirm'.
Select: Use the or the
P r
Enter/Adjust: Use the
P r
buttons.
Confirm: Use the button.
OK

Emergency interrupt

Both the video recorder and the remote control have an
'Emergency interrupt' button. You can use the
ton to interrupt any function.
Whenever you have operating problems you can simply
interrupt the function and start again.
You can practise operating your set without any worries. No
matter which buttons you press, you cannot damage it.
Autoinstall
The video recorder will search for all TV channels. It stores TV
channels found in the following sequence: BBC 1, BBC 2, ITV,
CH 4, CH 5, SKY, others.
4
EXT.2
20:00 21:30
gTIMER CLEAR gCL
D/WgSELECT OK
button.
P q
or the button, or the
P q
STANDBY m
1
Switch on the TV set. Press the
the video recorder. If TV channels have already been
stored, select the line 'AUTOINSTALL', using the
sock-
P r button.
2
Confirm with the
'AUTOINSTALL' starts. On the TV screen appears:
Wait until all TV channels have been found. This can take
several minutes.
3
When Autoinstall is complete, READYwill appear in the
display. Date and clock information have been set.
How to search for a TV channel manually, you can read in
chapter 4 'SPECIAL FEATURES', 'Manual channel search'.
Note: button you can interrupt the automatic channel
OK
search. All TV channels found will remain stored.
* If a TV channel transmits a 'TV channel identification' (e.g.
'BBC1'), it appears in the display.

Setting the clock

0-9
If the time in the video recorder display is not correct or if
'--:--' appears in the display, please set the clock manually.
1
Switch on the TV set.
2
Press the
AUTOINSTALL
3
Confirm the line 'CLOCK' with the
4
Adjust 'TIME', 'YEAR', 'MONTH', 'DATE' if required, using
but-
the P q or
5
Confirm each entry with the
Note: If a TV channel which transmits TXT/PDC is stored
with programme number 'P 01', time (from TXT) and date
(from PDC) will automatically be taken from the TXT/PDC
information.
AUTOINSTALL
button.
OK
AUTOINSTALL 00
button on the video recorder.
button.
OK
P r button or the digit buttons
TIME 20:00
YEAR 1998
MONTH 01
DATE 01
------------------------
-/+ OK
button.
OK
button on
P q or
.
0-9