Gigabyte GA-MA78G-DS3HP User Manual page 75

C. Configuring RAID set in RAID BIOS
Enter the RAID BIOS setup utility to configure a RAID array. Skip this step if you do not want to create
RAID.
Step 1:
After the POST memory test begins and before the operating system boot begins, look for a message
which says "Press <Ctrl-F> to enter FastBuild (tm) Utility" (Figure 2). Hit the <Ctrl>+<F> key to enter the
RAID BIOS setup utility.
RAID BIOS Version 3.0.1540.28
(c) 2007 Advanced Micro Devices, Inc. All rights reserved.
No Array is defined..
Press <Ctrl-F> to enter FastBuild (tm) Utility...
Step 2:
Main Menu
This is the first option screen when you enter the BIOS RAID Setup utility. (Figure 3).
To view the disk drives assigned to arrays, press <1> to enter the View Drive Assignments window.
To create an array, press <2> to enter the Define LD window.
To delete an array, press <3> to enter the Delete LD window.
To view controller settings, press <4> to enter the Controller Configuration window.
FastBuild (tm) Utility (c) 2007 Advanced Micro Devices, Inc.
Press 1..4 to Select Option
[
View Drive Assignments...........................[ 1 ]
Define LD..................................................[ 2 ]
Delete LD.................................................. [ 3 ]
Controller Configuration............................ [ 4 ]
[ Keys Available
Figure 2
Main Menu ]
]
Figure 3
- 75 -
[ESC] Exit
Appendix