Gigabyte GA-MA78G-DS3HP User Manual page 42

When you use an AM2 CPU:
DDR 400
DDR 533
DDR 667
DDR 800
When you use an AM2+ CPU:
X2.00
X2.66
X3.33
X4.00
X5.33
DCTs Mode
(Note)
Allows you to set memory control mode.
Ganged
Unganged
******* System Voltage Optimized
System Voltage Control
Determines whether to manually set the system voltages. Auto lets BIOS automatically set the
system voltages as required. Manual allows all voltage control items below to be configurable.
(Default: Auto)
DDR2 Voltage Control
Allows you to set memory voltage.
Normal
+0.1V ~ +0.5V
NorthBridge Volt Control
Allows you to set the North Bridge voltage.
Normal
+0.1V ~ +0.3V
SouthBridge Volt Control
Allows you to set the South Bridge voltage.
Normal
+0.1V ~ +0.3V
CPU NB VID Control
Allows you to set the CPU Northbridge VID voltage. Normal sets the CPU Northbridge VID voltage
as required. (Default: Normal)
Note: Increasing CPU voltage may result in damage to your CPU or reduce the useful life of the CPU.
CPU Voltage Control
Allows you to set the CPU voltage. Normal sets the CPU voltage as required. The adjustable range
is dependent on the CPU being installed. (Default: Normal)
Note: Increasing CPU voltage may result in damage to your CPU or reduce the useful life of the CPU.
Normal CPU Vcore
Displays the normal operating voltage of your CPU.
(Note) This item is present only if you install a CPU that supports this feature.
GA-MA78G-DS3H/DS3HP Motherboard
Sets Memory Clock to DDR 400.
Sets Memory Clock to DDR 533.
Sets Memory Clock to DDR 667.
Sets Memory Clock to DDR 800.
Sets Memory Clock to X2.00.
Sets Memory Clock to X2.66.
Sets Memory Clock to X3.33.
Sets Memory Clock to X4.00.
Sets Memory Clock to X5.33.
Sets memory control mode to single dual-channel.
Sets memory control mode to two single-channel.
********
Supplies the memory voltage as required. (Default)
Increases memory voltage by 0.1V to 0.5V at 0.1V increment.
Supplies the North Bridge voltage as required. (Default)
Increases North Bridge voltage by 0.1V to 0.3V at 0.1V increment.
Supplies the South Bridge voltage as required. (Default)
Increases South Bridge voltage by 0.1V to 0.3V at 0.1V increment.
(Note)
- 42 -