Gigabyte GA-770T-USB3 User Manual page 24

7) IDE (IDE Connector)
The IDE connector supports up to two IDE devices such as hard drives and optical drives. Before attach-
ing the IDE cable, locate the foolproof groove on the connector. If you wish to connect two IDE devices,
remember to set the jumpers and the cabling according to the role of the IDE devices (for example,
master or slave). (For information about configuring master/slave settings for the IDE devices, read the
instructions from the device manufacturers.)
8) SATA2_0/1/2/3/4/5 (SATA 3Gb/s Connectors, Controlled by AMD SB710 South Bridge)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard.
Each SATA connector supports a single SATA device. The AMD SB710 controller supports RAID 0,
RAID 1, RAID 10 and JBOD. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on
configuring a RAID array.
• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard
drives are to be used, the total number of hard drives must be an even number.
• A RAID 10 configuration requires at least four hard drives and the total number of hard drives
must be an even number.
Hardware Installation
40
7
SATA2_1
SATA2_0
1
- 24 -
39
DEBUG
PORT
2 1
1
SATA2_3
SATA2_2
7
SATA2_5
7 1
1 7
SATA2_4
Please connect the L-shaped end of
the SATA cable to your SATA hard
drive.
DEBUG DEBUG
PORT PORT
DEBUG
PORT
DEBUG
PORT
Pin No. Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
DEBUG
PORT