Ide Configuration - ASROCK 775i65G User Manual

3.3.4 IDE Configuration

3.3.4 3.3.4 3.3.4 3.3.4 IDE Configuration IDE Configuration IDE Configuration IDE Configuration
BIOS SETUP UTILITY
Advanced
IDE Configuration
[Enhanced Mode]
Onboard IDE Operate Mode
OnBoard IDE Controller [Both]
Primary IDE Master [Hard Disk]
Primary IDE Slave [Not Detected]
Secondary IDE Master [Not Detected]
Secondary IDE Slave [Not Detected]
SATA1
[Not Detected]
SATA2 [Not Detected]
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Onboard IDE Operate Mode
Please select [Compatible Mode] when you install legacy OS (Windows
ME / 98SE) into SATA device. If you install legacy OS into IDE HDD while
SATA devices are used, you also need to select [Compatible Mode].
If native OS (Windows
®
[Enhanced Mode]. You also need to select [Enhanced Mode] while native
OS is installed into IDE HDD and SATA devices are used.
If you do not install any SATA device, please also select [Enhanced Mode]
no matter you use legacy OS or native OS for the system.
Please note that the following options will be varied depending on the "Onboard
IDE Operate Mode" ([Compatible Mode] or [Enhanced Mode]) that you
selected.
When [Enhanced Mode] is selected:
OnBoard IDE Controller
You may enable either the primary IDE channel or the secondary IDE channel.
Or you may enable both the primary and the secondary IDE channels by
selecting [Both]. Set to [Disabled] will disable the both. Configuration options:
[Disabled], [Primary], [Secondary], [Both].
When [Compatible Mode] is selected
Combined Mode Option
It allows you to select between [Pri IDE + SATA] and [SATA + Sec IDE]. If it
is set to [Pri IDE + SATA], then the secondary IDE will not work. Likewise, if it
is set to [SATA + Sec IDE], then the primary IDE will not work.
Because Intel
under legacy OS (Windows
[Pri IDE + SATA] or [SATA + Sec IDE] when the installed SATA device
is used with legacy OS.
Set [Compatible Mode]
when both Legacy OS
(MS-DOS, Win Me / 98SE)
and SATA device
are used.
Set [Enhanced Mode]
when Native OS
(Win 2000 / XP)
is used.
Select Screen Select Screen
Select Item Select Item
+- +- Change Option Change Option
F1 F1 General Help General Help
F9 F9 Load Defaults Load Defaults
F10 F10 Save and Exit Save and Exit
ESC ESC Exit Exit
2000 / XP) is installed into SATA device, please select
ICH5 south bridge only supports four IDE devices
®
ME / 98SE), you have to choose either
®
®
3 3 3 3 3 3
3 3 3 3