Table of Contents
Advertisement
To replace the oven light bulb (cont'd):
2.
Press wire holder to one side to release the glass shield
that covers the light bulb.
3.
Replace bulb with a new 40 watt appliance bulb.
4.
Replace glass shield over bulb and snap wire holder back
into place.
5.
Turn power back on again at the main source (or plug
the appliance back in).
6.
The clock will then need to be reset. To reset, see
"Setting the clock" in this Use & Care Guide.
Removing and replacing the lift-off oven door
CAUTION
The door is heavy. For safe, temporary storage, lay the door
flat with the inside of the door facing down.
To remove oven door:
1.
Open oven door completely (horizontal with floor - See
Fig. 1).
2.
Pull the door hinge locks on both left and right door
hinges down from the oven frame completely towards
the oven door (See Fig. 2). A tool such as a small flat-
blade screwdriver may be required.
3.
Firmly grasp both sides of oven door along the door sides
(Do not use the oven door handle - See Fig. 3).
4.
Close the door to the broil stop position (the oven door
will stop into this position just before fully closing).
5.
With the oven door in the broil stop position, lift the
oven door hinge arms over the roller pins located on each
side of the oven frame (See Fig. 4).
To replace oven door:
1.
Firmly grasp both sides of oven door along the door sides
(Do not use the oven door handle - See Fig. 3).
2.
Holding the oven door at the same angle as the removal
position, seat the hook of the hinge arm over the roller
pins located on each side of the oven door frame (See
Fig. 4). The hook of the hinge arms must be fully seated
onto the roller pins.
3.
Fully open the oven door (horizontal with floor - See Fig.
1).
4.
Push the door hinge locks up towards and into the oven
frame on both left and right oven door hinges (See Fig.
2) to the locked position.
5.
Close the oven door.
Special door care instructions - Most oven doors
contain glass that can break. Read the following
recommendations:
1.
Do not close the oven door until all the oven racks are
fully in place.
2.
Do not hit the glass with pots, pans, or any other object.
3.
Scratching, hitting, jarring or stressing the glass may
weaken its structure causing an increased risk of breakage
at a later time.
CARE & CLEANING
Oven door
hinge
locations
with oven door
fully open.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
31
Hide quick links:
Advertisement
Table of Contents
