Table of Contents
Advertisement
Replacing
oven light
Be sure the range is unplugged and all parts are COOL before
replacing oven light. Weara leather-faced glove for protection
against possible broken glass.
The light bulb is located at the rear of the oven cavity and is
covered with a glass shield held by a wire holder. The glass
shield must be in place whenever the oven is in use.
Special door care instructions
= Most oven doors
contain glass that can break, Read the following
recommendations:
•
Do not close the oven door until all the oven racks are fully
in place.
•
Do not hit the glass with pots, pans, or any other object.
•
Scratching, hitting, jarring or stressing the glass may
weaken its structure causing an increased risk of breakage
at a later time.
To replace the oven light bulb:
1.
Turn electrical
power off at the main source or unplug
the range.
2.
Press wire holder to one side to release the glass shield
that covers the light bulb.
3.
Replace bulb with a new 40 watt appliance bulb.
4.
Replace glass shield over bulb and snap wire holder back
into place.
5.
Turn power back on again at the main source (or plug
the appliance back in).
6.
The clock will then need to be reset. To reset, see
"Setting the clock" in this Use & Care Guide.
Fig. 1
Removing
and replacing the Eft-off oven door
The oven door is heavy. For safe, temporary storage, lay the
oven door flat with the inside of the door facing down.
To remove
oven door:
1.
Open oven door completely
(horizontal
with floor - Fig.l).
2.
Pull the door hinge locks on both left and right door
hinges down from the oven frame completely
towards
the oven door (Fig. 2). A tool such as a small fiat-blade
screwdriver
may be required.
3.
Firmly grasp both sides of oven door along the door sides
(Do not use the oven door handle - Fig. 3).
4.
Close the door to the broil stop position (the oven door
will stop into this position just before fully closing).
5.
With the oven door in the broil stop position, lift the
oven door hinge arms over the roller pins located on each
side of the oven frame (Fig. 4).
To replace
oven door:
1.
Firmly grasp both sides of oven door along the door sides
(Do not use the oven door handle - Fig. 3).
2.
Holding the oven door at the same angle as the removal
position, seat the hook of the hinge arm over the roller
pins located on each side of the oven door frame (Fig. 4).
The hook of the hinge arms must be fully seated onto
the roller pins.
3.
Fully open the oven door (horizontal
with floor - Fig. 1).
4.
Push the door hinge locks up towards and into the oven
frame on both left and right oven door hinges (Fig. 2) to
the locked position;
then close the oven door.
Oven
Door
Fig. 2
Fig. 3
Fig. 4
Advertisement
Table of Contents
