How It Works; Positioning The Dehumidifier; Wall Mounting - Amcor D850E Instruction Manual

See page 3, fig. 3
Your Amcor dehumidifier controls the
Relative Humidity by passing the air
through the unit forcing the excess
moisture to condensate over the cooling
elements.
This condensate water then flows safely
There must be free space of at least 30 cm between any other object and
the front and the top of the unit.
Your Amcor dehumidifier can be
installed in any area with a too high
relative humidity, such as cellar, playing
area, shed, archive or swimming pool.
The dehumidifier will begin to protect
from the harmful effects of excess
moisture as soon as it is plugged in and
switched on.
When positioning your Amcor
dehumidifier, ensure that it is placed on
a level surface.
See page 3, fig. 5
The unit can stand on the floor or hung
on a wall. All necessary items for wall
mounting are supplied in the plastic bag.
Fix the supporting bracket with at least 5
screws horizontally to the wall, use the
plugs for better fastening.
into a fixed drain.
The dried air then passes through a final
heat exchanger where it is slightly
warmed and re-enters the area at a
slightly elevated temperature.
The level of demoistering is set with the
humidistat control.

Positioning the dehumidifier

Positioning the dehumidifier
Best results are obtained when windows
and doors are closed, thus preventing
the possible influx of fresh, too humid,
air.
When the unit is placed in a (swimming)
pool, connect to the mains via a
transformer or a breaking switch,
conform the local regulations regarding
electrical installations.
When the dehumidifier is in operation,
open outside doors and windows only
when necessary.
Hang the unit on the bracket, the two
tongues fit into the slots on the unit's rear
panel.
Make sure the two rubber pads (3) on
the tongues and the two rubber supports
(4) on the lower part of the rear panel
are properly placed.

How it works

How it works

Wall mounting

Wall mounting
GB
5