Basic Engine - MULTIQUIP QP305SLT Operation And Parts Manual

High pressure centrifugal pump (honda gx340k1pkt2/gx340u1pkt2 gasoline engine)
Hide thumbs Also See for QP305SLT:
Table of Contents

Advertisement

INITIaL SeRvICINg
The engine (See Figure 3) must be checked for proper
lubrication and filled with fuel prior to operation. Refer to the
manufacturer's engine manual for instructions and details
of operation and servicing. The engine shown above is a
HONDA engine, operation for other types of engines may
vary somewhat.
1. Fuel Filler Cap — Remove this cap to add unleaded
gasoline to the fuel tank. Make sure cap is tightened
securely. do NoT over fill.
daNgeR
Adding fuel to the tank should be done
only when the engine is stopped and has
had an opportunity to cool down. In the
event of a fuel spill, do NoT attempt to
start the engine until the fuel residue has
been completely wiped up and the area
surrounding the engine is dry.
2. Throttle Lever — Used to adjust engine RPM speed
(lever advanced forward - SLOW, lever back toward
operator - FAST).
3. engine oN/oFF Switch — ON position permits engine
starting, OFF position stops engine operations.
4. Recoil Starter (pull rope) — Manual-starting method.
Pull the starter grip until resistance is felt, then pull
briskly and smoothly.
page 14 —Qp305SLT/QpT305SLT CeNTRIFUgaL pUMp • opeRaTIoN aNd paRTS MaNUaL — Rev. #1 (10/11/10)
Figure 3. Engine Controls and Components
5. Fuel valve Lever — opeN to let fuel flow. CLoSe to
stop the flow of fuel.
6. Air Cleaner — Prevents dirt and other debris from
entering the fuel system. Remove wing-nut on top of
air filter cannister to gain access to filter element.
NOTICE
Operating the engine without an air filter, with a
damaged air filter, or a filter in need of replacement
will allow dirt to enter the engine, causing rapid engine
wear.
WARNING
Engine components can generate
extreme heat. To prevent bur ns,
do NoT touch these areas while the
engine is running or immediately after
operating. NeveR operate the engine with
the muffler removed.
7. Spark Plug — Provides spark to the ignition system.
Set spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch).
Clean spark plug once a week.
8. Muffler — Used to reduce noise and emissions.
9. Fuel Tank — Holds unleaded gasoline. For additional
information refer to engine owner's manual.

basiC enGine

Advertisement

Table of Contents
loading

This manual is also suitable for:

Qpt305slt

Table of Contents