Step 5: Installing An Sfp Transceiver Module - NETGEAR GS752TXS Hardware Installation Manual

GS752TXS Smart Switch Hardware Installation Guide
Link/Act Mode
Power
Green=Link at 1G
Fan
Yellow=Link at 10/
Stack
Master
ID
Reset Factory
Defaults
Figure 7. Connecting Devices to the Switch
Connect each PC to an RJ-45 network port on the Switch front panel
Category 5 (Cat5) Unshielded Twisted-Pair (UTP) cable terminated with an RJ-45 connector
to make these connections.
Note: Ethernet specifications limit the cable length between the switch and
the attached device to 100m (328 ft.).

Step 5: Installing an SFP Transceiver Module

The following procedure describes how to install an optional SFP(or SFP+) transceiver
module into one of the SFP ports of the switch.
Note: Contact your NETGEAR sales office to buy these modules. If you do
not want to install an SFP module, skip this procedure.
To install an SFP transceiver, insert the transceiver into the SFP port. Press firmly on the
flange of the module to seat it securely into the connector. You can install up to three
additional Gigabit or 10 Gigabit Ethernet modules using this procedure.
100M
SFP
+
Green=10G Link Yellow=1G
Blink=ACT
(Figure 7). Use
Chapter 4. Installation | 23