Philips DPTV345 User Manual page 34

The Blinking LED Procedure

The contents of the error buffer can also be made visible through the "blinking LED" procedure. This is

especially useful when there is no picture.

When the SDM is entered, the LED will blink the number of times equal to the value of the error code.

Error-codes equal to or greater10 are shown in the following manner: A long blink of 750 mSeconds

indicating the decimal digit, followed by a pause of 1500 mSeconds. The LED will then blink the number

equal to the error code. When all error-codes are displayed, the sequence is finished with an LED

display of 3 seconds. At this point the sequence will begin again.

Error code position

Error buffer:

After entering SDM: The sequence will begin with 1 long blink of 750 mSeconds, then pause 1500

mSeconds, then blink twice (indicating error code 12), then the LED will pause for 3 seconds, then blink

9 times (indicating error code 9), then the LED will pause for 3 seconds, then blink 6 times (indicating

error code 6), then pause 3 seconds and blink for 3 seconds again, ending the blinking sequence.

NOTE: If errors 1, 2, 3, or 4 occur the LED ALWAYS blinks indicating the last error which occurred, even if the

set is NOT in service mode.

Option Codes - NAFTA