Advertisement
8. Now, lift the back edge of the Chassis Frame (nearest you), up while also lifting (slightly), the front edge
to slide forward in to the Service Position shown.
Service Position Detail - E
Mirror Mounting Board (AC18)
1. Remove 6 screws located in the mirror mounting board brackets and remove the board.
Note: Care should be taken NOT to place fingerprints or smudges on the mirror.
Side Back Covers
1. Remove 4 screws (F) from each of the Side Back Covers. (Some prying may be necessary to dislodge
covers.
Note: This allows access to the Side Jack Panel and Left and Right Speakers.
Large Signal Panel
1. Remove 3 screws from center of the CBA and pull 3 tabs on right of bracket.
2. Lift right side of LSP and slide panel up and out.
Power Supply Panel
1. Remove 4 screws from CBA.
2. Lift PFC Filter Panel up and out.
Advertisement
