X-10 X10 PRO XP4LS Installation And Operating Instructions Manual page 9

Mode 5 Programming - Setting Advanced Programming Options
The Advanced Programming Options are given the following table. The sequence of
programming is different for these options, so we will separate them as follows.
Advanced Programming Options 1 through 7
1) Enter Mode 5. See To Enter any Mode section.
2) Press Advanced Programming Option number. A number between 1 and 7 as
defined in the following table.
3) Press All-Lights-On key. Product confirms Option Number is entered.
4) Press all applicable Channel Numbers. A number representing which channel you
want to change. LM4s have channel numbers 1 through 4. MM2s have channel
numbers 1 and 2. SS1s have only channel number 1.
5) Press the ON key or OFF key. Pressing ON or OFF key will determine if the
channel will respond or not respond to the Scene Address.
6) Press All-Lights-On key. The product stores new setting into memory.
7) Press All-Lights-On key 3 times. The product is transferred out of programming
mode and into normal operation.
Advanced Programming Options 8 and 10
1) Enter Mode 5. See To Enter any Mode section.
2) Press Advanced Programming Option number. Number 8 or 10 as defined in the
following table.
3) Press All-Lights-On key. Product confirms Option Number is entered.
4) Press the ON key or OFF key. Pressing ON or OFF key will determine if the
channel will respond or not respond to this option.
5) Press All-Lights-On key. The product stores new setting into memory.
6) Press All-Lights-On key 3 times. The product is transferred out of programming
mode and into normal operation.
Page 9